BRASS PUSH-ON HOSE BARB FITTINGS
PUSH-ON HOSE BARB FITTINGS TYPICAL APPICATION: LOW PRESSURE AIR, FUEL, LUBE, AND OIL LINES.
MATERIAL: CA360 BRASS
PRESSURE DETERMINED BY TUBE MATERIAL AND HARDNESS. BRASS PUSH-ON HOSE BARBS IN THIS SECTION HAVE BEEN TESTED TO MAX 150 PSI.
ADVANTAGES: EASY ASSEMBLY. NO CLAMPS REQUIRED.
Assembly Instructions
1- Lubricate insert.
2- Hold hose at angle as shown & push on and up over
first barb.
3- Continue to push straight on until hose is seated under
protective plastic cap. Keep hands back from hose end
area so that hose can expand.
Disassembling Instructions
1- Split hose as shown above. Do not cut completely
through hose. Sealing edge of barb could be damaged.
2- Bend hose and remove with a quick pull.
ACTUAL PROFILE OF PUSH ON BARBS
1/4 INCH HOSE ID = 0.345 INCHES ACTUAL PROFILE
5/16 INCH HOSE ID = 0.41 INCHES ACTUAL PROFILE
3/8 INCH HOSE ID = 0.47 INCHES ACTUAL PROFILE
1/2 INCH HOSE ID = 0.60 INCHES ACTUAL PROFILE
5/8 INCH HOSE ID = 0.725 INCHES ACTUAL PROFILE
3/4 INCH HOSE ID = 0.85 INCHES ACTUAL PROFILE
© 2024 FastFittings.com. Powered by Shopify
